|Posted by obd2tool 2012 on December 18, 2021 at 4:00 AM|
Here is a document on how to repair JCB equipment K4718 trouble code intake manifold pressure drop too high at cranking.More repair case for JCB,please refer to:JCB Trouble Repair
The measured intake manifold pressure (the signal from the boost pressure sensor) is below the warning limit during engine cranking.
Possible causes are:
The engine air supply is clogged.
The boost pressure sensor wiring is defective.
The boost pressure sensor is defective.
Reaction in EEM
The FC is stored and the warning lamp is activated. The CAN message indicates active fault.
NOTE:The engine may not start, or it starts slowly and runs poorly.
Check the engine air supply system completely, consult the service instructions if necessary.
Check the air filter.
Check the piping from the air filter to the turbocharger (look for obstacles in the joints, the bends).
Check the turbocharger.
Check the piping from the turbocharger to the charge air cooler (look for obstacles in the joints, the bends).
Check the charge air cooler.
Check the piping from the charge air cooler to the inlet manifold (look for obstacles in the joints, the bends).
To check the electrical defects, check the boost pressure sensor, the sensor wiring and the controller input: First save the error log and then erase it. Restart the ECU after erasing the error log. If the fault occurs again during the next driving cycle, check the following paths:
Check the boost pressure sensor wiring, the connectors and the contact surfaces of the connector pins (possible oxidation).
Check the operation with another boost pressure sensor to see if the boost pressure sensor is defective.
JCB Electronic Service Tool diagnostic interface is used for fast and effective fault finding, check maintenance standards, see if the machine has been abused, view and change machine set up data, flash ECUs with the correct data files. You can resetEMShours, edit speed limiters and use other functions what require special unlock.
JCB Service Master is a gateway application allowing a large number of Vehicle Support Applications to be linked using one familiar interface. The interface acts as a graphical tool for selecting the target vehicle from a groups of Vehicle Families and triggering the particular Service Tool Application desired. This removes the need for a user to ‘remember’ every individual service tool available and select which one if intended for a particular machine.
The JCB Service Master also provides several key features that will accompany all JCB projects, a Multi Language editing tool that provides a means of individual text string translation for all JCB Applications and a means to select a localised language translation for the each JCB Application.